Oxidation is one of those subjects where the details matter more than the headlines. This page pulls together the background, the mechanisms, and the practical points readers ask about most.
Last reviewed on 2026-04-20. Where a claim depends on a specific study, the study is described rather than over-claimed.
Peptides are short chains of amino acids linked by amide bonds, and their storage stability depends on sequence, length, and three-dimensional structure. Chemical degradation can occur through hydrolysis, oxidation, deamidation, and aggregation, while physical changes such as precipitation or surface adsorption reduce recovery. Storage conditions are chosen to slow these processes without altering the peptide itself. Because peptides vary widely, no single condition suits every sequence, so laboratories often establish stability empirically for each batch.
Temperature is a primary factor because most degradation reactions proceed more slowly at lower temperatures. Lyophilized peptides are commonly held at -20 °C or below, although some sequences remain stable at 2–8 °C for limited periods. Moisture uptake during handling can accelerate hydrolysis, so sealed containers and desiccants are used. Solutions are generally less stable than powders and may require freezing at -80 °C or refrigeration, depending on the peptide. Repeated freeze-thaw cycles can promote aggregation even when the storage temperature is otherwise suitable.
Reconstitution is often performed with sterile water, buffer, or a water-miscible organic solvent, depending on solubility. The solvent should be added gently along the vial wall, and the solution mixed by gentle swirling rather than vigorous vortexing, which can cause foaming and surface denaturation. Some sequences require a small amount of base or acid to dissolve, followed by pH adjustment. Preparing a concentrated stock solution can simplify later dilution, but the stock itself may have limited stability. Records of solvent, concentration, and date support reproducibility.
After reconstitution, dividing the solution into single-use aliquots limits multiple warming and cooling events and reduces contamination risk. Low-binding polypropylene tubes are often preferred because peptides can adsorb to glass or untreated plastic surfaces. Filling headspace with nitrogen or argon can slow oxidation, and amber or foil-wrapped containers reduce photodegradation. Each aliquot should be labeled with peptide identity, concentration, date, and storage conditions. Frozen aliquots should be thawed quickly and kept on ice until use.
When a peptide arrives, the vial should be inspected for damage, and its label, lot number, and accompanying analytical data should be recorded. Cold vials should equilibrate to room temperature before opening to prevent condensation on the powder. Moisture uptake can reduce stability and complicate accurate weighing or reconstitution. Inventory systems that track date, quantity, and storage location help prevent unnecessary temperature cycling. Personnel should follow institutional or manufacturer instructions for any specific peptide.
| Property | Value | Notes |
|---|---|---|
| Appearance (lyophilized) | White to off-white powder | May appear fluffy, crystalline, or amorphous depending on manufacturing |
| Solubility class | Typically water-soluble | Solubility varies with sequence and pH; some require organic co-solvents |
| Typical storage temperature (lyophilized) | -20 °C or lower | Some peptides tolerate 2–8 °C; moisture control is critical |
| Typical storage temperature (solution) | -80 °C to 2–8 °C | Depends on peptide; avoid repeated freeze-thaw cycles |
| Common analytical method | Reverse-phase HPLC | Used for purity, identity, and degradation monitoring; mass spectrometry often confirms mass |
Donald has supervised many students and postdocs, many of whom are now professors in reputed universities such as MIT, Carnegie-Mellon University, University of Washington, Seattle, University of Massachusetts Amherst, Dartmouth College, Duke University, Middlebury College and University of Toronto, and researchers at organizations such as NIAID, NIST, IBM, Sandia National Laboratories. Donald is the son of historian David Herbert Donald and historian and editor Aida DiPace Donald. MEMS Protein design NMR Protein Structure Kinodynamic planning Donald is the author of over 100 publications. A representative selection includes:
In 2004, development of an antisense therapy for spinal muscular atrophy began. Over the following years, an antisense oligonucleotide later named nusinersen was developed by Ionis Pharmaceuticals under a licensing agreement with Biogen. In December 2016, nusinersen received regulatory approval from FDA and soon after, from other regulatory agencies worldwide. As of 2020, more than 50 antisense oligonucleotides were in clinical trials, including over 25 in advanced clinical trials (phase II or III). A follow-on drug to Inotersen is being developed by Ionis Pharmaceuticals and under license to Akcea Therapeutics for hereditary transthyretin-mediated amyloidosis. In this formulation the ASO is conjugated to N-Acetylgalactosamine enabling hepatocyte-specific delivery, greatly reducing dose requirements and side effect profile while increasing the level of transthyretin reduction in patients.
The F1 portion of ATP synthase is hydrophilic and responsible for hydrolyzing ATP. The F1 unit protrudes into the cytoplasm (matrix and stroma in mitochondria and chloroplasts respectively). Subunits α and β make a hexamer with 6 binding sites. Three of them are catalytically inactive and they bind ADP. Three other subunits catalyze the ATP synthesis. The other F1 subunits γ, δ, and ε are a part of a rotational motor mechanism (rotor/axle). The γ subunit allows β to go through conformational changes (i.e., closed, half open, and open states) that allow for ATP to be bound and released once synthesized. The F1 particle is large and can be seen in the transmission electron microscope by negative staining. These are particles of 9 nm diameter that pepper the inner mitochondrial membrane.
Both the thyroid and adrenal glands can be infiltrated. It is estimated that 10–20% of people with amyloidosis have hypothyroidism. Adrenal infiltration may be harder to appreciate given that its symptoms of orthostatic hypotension and low blood sodium concentration may be attributed to autonomic neuropathy and heart failure. "Amyloid deposits occur in the pancreas of people who also have diabetes mellitus, although it is not known if this is functionally important. The major component of pancreatic amyloid is a 37-amino acid residue peptide known as islet amyloid polypeptide or 'amylin.' This is stored with insulin in secretory granules in [beta] cells and is co secreted with insulin." (Rang and Dale's Pharmacology, 2015.)
Sources: en.wikipedia.org
the cAMP signal pathway and the phosphatidylinositol signal pathway. When a ligand binds to the GPCR it causes a conformational change in the GPCR, which allows it to act as a guanine nucleotide exchange factor (GEF). The GPCR can then activate an associated G protein by exchanging the GDP bound to the G protein for a GTP. The G protein's α subunit, together with the bound GTP, can then dissociate from the β and γ subunits to further affect intracellular signaling proteins or target functional proteins directly depending on the α subunit type (Gαs, Gαi/o, Gαq/11, Gα12/13). GPCRs are an important drug target, and approximately 34% of all Food and Drug Administration (FDA) approved drugs target 108 members of this family. The global sales volume for these drugs is estimated to be 180 billion US dollars as of 2018. It is estimated that GPCRs are targets for about 50% of drugs currently on the market, mainly due to their involvement in signaling pathways related to many diseases i.e. mental, metabolic including endocrinological disorders, immunological including viral infections, cardiovascular, inflammatory, senses disorders, and cancer. The long ago discovered association between GPCRs and many endogenous and exogenous substances, resulting in e.g. analgesia, is another dynamically developing field of the pharmaceutical research.
The inverted terminal repeat (ITR) sequences comprise 145 bases each. They were named so because of their symmetry, which was shown to be required for efficient multiplication of the AAV genome. The feature of these sequences that gives them this property is their ability to form a hairpin, which contributes to so-called self-priming that allows primase-independent synthesis of the second DNA strand. The ITRs were also shown to be required for both integration of the AAV DNA into the host cell genome (19th chromosome in humans) and rescue from it, as well as for efficient encapsidation of the AAV DNA combined with generation of a fully assembled, deoxyribonuclease-resistant AAV particles. With regard to gene therapy, ITRs seem to be the only sequences required in cis next to the therapeutic gene: structural (cap) and packaging (rep) proteins can be delivered in trans. With this assumption many methods were established for efficient production of recombinant AAV (rAAV) vectors containing a reporter or therapeutic gene. However, it was also published that the ITRs are not the only elements required in cis for the effective replication and encapsidation. A few research groups have identified a sequence designated cis-acting Rep-dependent element (CARE) inside the coding sequence of the rep gene. CARE was shown to augment the replication and encapsidation when present in cis.
Databases are essential for bioinformatics research and applications. Databases exist for many different information types, including DNA and protein sequences, molecular structures, phenotypes and biodiversity. Databases can contain both empirical data (obtained directly from experiments) and predicted data (obtained from analysis of existing data). They may be specific to a particular organism, pathway or molecule of interest. Alternatively, they can incorporate data compiled from multiple other databases. Databases can have different formats, access mechanisms, and be public or private. Some of the most commonly used databases are listed below: Used in biological sequence analysis: Genbank, UniProt Used in structure analysis: Protein Data Bank (PDB) Used in finding Protein Families and Motif Finding: InterPro, Pfam Used for Next Generation Sequencing: Sequence Read Archive Used in Network Analysis: Metabolic Pathway Databases (KEGG, BioCyc), Interaction Analysis Databases, Functional Networks Used in design of synthetic genetic circuits: GenoCAD
Four members of 2A peptides family are frequently used in life science research. They are P2A, E2A, F2A, and T2A. F2A is derived from foot-and-mouth disease virus 18; E2A is derived from equine rhinitis A virus; P2A is derived from porcine teschovirus-1 2A; T2A is derived from thosea asigna virus 2A. The following table shows the sequences of four members of 2A peptides. Adding the optional linker “GSG” (Gly-Ser-Gly) on the N-terminal of a 2A peptide greatly helps with efficiency. 2A peptides trigger the ribosome to skip peptide bond formation between the glycine (G) and proline (P) near the C-terminus of the 2A peptide, resulting in the peptide located upstream of the 2A peptide having extra amino acids appended to its C-terminus while the protein downstream the 2A peptide will have an extra proline on its N-terminus. The exact molecular mechanism of 2A-peptide-mediated cleavage is still unknown. However, it is believed to involve ribosomal "skipping" of glycyl-prolyl peptide bond formation rather than true proteolytic cleavage.
Recombinant DNA technology arose as a result of advances in biology that began in the 1950s and '60s. During these decades, a tradition of merging the structural, biochemical, and informational approaches to the central problems of classical genetics became more apparent. Two main underlying concepts of this tradition were that genes consisted of DNA and that DNA encoded information that determined the processes of replication and protein synthesis. These concepts were embodied in the model of DNA produced through the combined efforts of James Watson, Francis Crick, Rosalind Franklin, and Maurice Wilkins. Further research on the Watson-Crick model yielded theoretical advances that were reflected in new capacities to manipulate DNA. One of these capacities was recombinant DNA technology.
Sources: en.wikipedia.org
A simple supersecondary protein topology composed of two or more consecutive antiparallel β-strands linked together by hairpin loops. This motif is common in β-sheets and can be found in several structural architectures including β-barrels and β-propellers. The vast majority of β-meander regions in proteins are found packed against other motifs or sections of the polypeptide chain, forming portions of the hydrophobic core that canonically drives formation of the folded structure. However, several notable exceptions include the Outer Surface Protein A (OspA) variants and the Single Layer β-sheet Proteins (SLBPs) which contain single-layer β-sheets in the absence of a traditional hydrophobic core. These β-rich proteins feature an extended single-layer β-meander β-sheets that are primarily stabilized via inter-β-strand interactions and hydrophobic interactions present in the turn regions connecting individual strands.
An aldehyde tag is a short peptide tag that can be further modified to add fluorophores, glycans, PEG (polyethylene glycol) chains, or reactive groups for further synthesis. A short, genetically-encoded peptide with a consensus sequence LCxPxR is introduced into fusion proteins, and by subsequent treatment with the formylglycine-generating enzyme (FGE), the cysteine of the tag is converted to a reactive aldehyde group. This electrophilic group can be targeted by an array of aldehyde-specific reagents, such as aminooxy- or hydrazide-functionalized compounds.
Years after the conference, people ascribed a large amount of significance to it. According to Paul Berg and Maxine Singer in 1995, the conference marked the beginning of an exceptional era for both science and the public discussion of science policy. The guidelines devised by the conference enabled scientists to conduct experiments with recombinant DNA technology, which by 1995 dominated biological research. This research, in turn, increased knowledge about fundamental life processes, such as the cell cycle. Additionally, the conference, along with public debates on recombinant DNA, increased public interest in biomedical research and molecular genetics. For this reason, by 1995, genetics and its vocabulary had become a part of the daily press and television news. This, in turn, stimulated knowledgeable public discussion about some of the social, political, and environmental issues that emerged from genetic medicine and the use of genetically modified plants in agriculture. Another significant outcome of the conference was the precedent it set about how to respond to changes in scientific knowledge. According to the conference, the proper response to new scientific knowledge was to develop guidelines that governed how to regulate it.
The general detection scheme involves: Pneumatic nebulization of mobile phase from the analytical column forming an aerosol. Aerosol conditioning to remove large droplets. Evaporation of solvent from the droplets to form dried particles. Particle charging using an ion jet formed via corona discharge. Particle selection – an ion trap is used to excess ions and high mobility charged particles. Measurement of the aggregate charge of aerosol particles using a filter/electrometer. The CAD like other aerosol detectors, can only be used with volatile mobile phases. For an analyte to be detected it must be less volatile than the mobile phase. More detailed information on how CAD works can be found on the Charged Aerosol Detection for Liquid Chromatography Resource Center.
Sources: en.wikipedia.org
Removing water reduces hydrolytic and some oxidative degradation. Powder forms are generally more stable for long-term storage than solutions. Stability still depends on peptide sequence, residual moisture, and container conditions.
Freezing slows most chemical reactions, but it can also concentrate solutes and promote aggregation during freezing or thawing. Repeated freeze-thaw cycles are often more damaging than constant cold storage. Some peptides require specific buffers or additives to remain soluble.
pH affects charge, solubility, and the reactivity of amino acid side chains. It can influence deamidation, oxidation, and aggregation pathways. The best pH is peptide-specific and is usually identified through stability testing.
Dividing a stock into single-use portions usually reduces multiple thawing and refreezing events and lowers contamination risk. It also allows a needed amount to be removed without warming the entire supply.